Welcome! Let’s grow the hydrogen economy together. › Let’s grow the hydrogen community! › Questions & Answers › Is condensate buildup within PEM fuel cell stack housings a problem?

  • Is condensate buildup within PEM fuel cell stack housings a problem?

    Posted by greghart on October 23, 2024 at 19:26

    Stack housings or enclosures in PEM fuel cell systems are often if not always ventilated to prevent the buildup of dangerous amounts of hydrogen from potential stack leakage. With ambient air as a venting media and fluctuating temperatures with use, there is a possibility that condensate will buildup within the enclosure, causing issues with isolation resistance. How big of an issue is this actually? Do additional measures need to be taken when designing a ventilation system to account not only for H2 but also humidity/water buildup?

    greghart replied 7 months, 3 weeks ago 2 Members · 2 Replies
  • 2 Replies
  • Roger Penn

    Member
    October 30, 2024 at 14:05

    Yes, both H2 emissions and condensate buildup must be accounted for when calculating ventilation flow through the housing or stack enclosure. Depending on the stack design (seal material), the air flow may need to be higher to remove moisture than for removing fugitive H2 emissions. If moisture builds up inside the housing it will gradually pick up ions from the housing material, dust from ventilation air, etc. and can become conductive, causing a loss/reduction of stack isolation or even a ground fault.

    After the fuel cell system is shut-down, the warm air in the housing will cool down and water will condense inside. I have opened up housings where drops of water were hanging on the roof of the housing and if you tapped on the housing it would rain inside (and onto the stack). Once the system is up to temperature and warm air can be flowed through the housing, it can evaporate the moisture and remove it from the housing. Ventilation air flow can be supplied by a separate blower, or it can be pulled (suction) from the housing by air compressor. Either way, the flow needs to be sufficient for the expected stack external H2 leaks and the build up of moisture (calculate both and flow the higher rate required).

    • greghart

      Member
      March 22, 2026 at 19:40

      Hello,

      Thank you very much for the detailed answer and insights!

      All the best, Gregory

Log in to reply.